Products

Flat Produts

Hot Rolled Coil (HRC)

Hot rolled coil is rolled on a hot strip mill from slabs. It can be found on the market in coil or sheet form and is further processed into finished products by the manufacturer. Hot rolled coil is typically 2-25mm thick and up to 2,250mm wide

 Cold Rolled Coil (CRC)

Cold rolled steel is a ‘flat’ steel product. The material is manufactured from hot rolled steel, the thickness of which is further reduced on a strip mill without the use of heat. The resulting thinner and flatter material is known as cold rolled steel. Typical thickness is from 0.15 to 3 mm. Typical width is from 600 to 2,100 mm.

 Hot Dipped Galvanized Coil / Sheet

 Obtained by passing cold rolled coil through a molten zinc bath, in order to coat the steel with a thin layer of zinc to provide corrosion resistance. Hot dipped galvanized coil can be found on the market in coil or in sheets and is further processed into finished products by the manufacturer. Typical thickness is from 0.3 to 3 mm. Typical width is from 600 to 2,100 mm.

 Coated Steel Coil

 Color coated, or pre-painted steel, is steel coil to which a paint, powder or film coating has been applied in a continuous process prior to it being cut and shaped. It provides a durable uniform surface finish, and can be an alternative to conventional post-manufacture painting of steel parts. The coil is coated on one or both sides. Rolls apply first a primer and then a topcoat to the moving steel strip. The substrate is usually cold reduced galvanized coil, but galvanized HRC and even uncoated coil is used.

 Cold Rolled Sheet

 Flat rolled products for which the required final thickness has been obtained by rolling at room temperature. To meet the various end use requirements, cold-rolled sheet products are metallurgically designed to provide specific attributes such as high formability, deep drawability, high strength, high dent resistance, good magnetic properties, enamelability and paintability.

Long Products

Reinforcing Bar

Reinforcing bar (or Rebar) is formed from a steel billet, normally having surface deformations for use in reinforcing concrete. The bar can be produced in straight lengths as well as coiled.

 Merchant Bar

Merchant bar is a range of commodity carbon steel long products including round, square and hexagonal bars, angles, channels and flats. Maximum diameter or width is usually 80-100mm, although flats up to 150mm wide are included. These are a staple item for many steel stockholders, large or small.

 Structural Sections

Heavy or structural sections are steel products such as beams or columns which are usually formed with a specific cross section shape e.g. H, I or U.

Wire Rod

Hot rolled from steel billet, wire rod is delivered as coil, most commonly at 5.5mm dia, but in sizes up to 60mm dia. Close control of final cooling is a critical part of production. The most important characteristic for determining a rod’s end use is its drawability; the extent to which the rod’s diameter can be reduced during the drawing process.

Champion International Steel do except orders per customers request and specifications.